OpenIMU300RI Eval KitΒΆ

The OpenIMU300RI evaluation kit includes:

  • A robust and easy-to-use test fixture.
  • An OpenIMU300RI IMU module attached to the test fixture with JTAG (SWD) 20-pin connector.
  • An ST-LINK J-TAG debugger, a debugger cable, and a USB cable.
  • A multiple-connector cable for RS232/CAN/Power connection.
_images/OpenIMU-Unlabeled-box.png _images/STLink.png

OpenIMU300RI Evaluation Kit Introduction

The OpenIMU evaluation kit is a hardware platform used to evaluate the OpenIMU300RI inertial navigation system and develop various applications based on this platform. It is supported by the Aceinna Navigation Studio, which provides easy access to the features of the OpenIMU300RI and explains how to integrate the device in a custom design. The Components section below provides the contents of the kit.

Note

An external DC power supply is required. The power supply must be able to provide 400mA at 4.9VDC to 32VDC.

The cable shown in the Evaluation Kit figure may look different than the cable that will be provided with the Evaluation Kit

_images/OpenIMU300RI_DevKit.png
_images/OpenIMU300RI-EvalKit.png
OpenIMU300RI Evaluation Unit
installed on test fixture with JTAG connector
OpenIMU300RI Evaluation Kit

OpenIMU300RI Evaluation Kit components

OpenIMU300RI unit

OpenIMU300RI is 9 DOF (degrees of freedom) fully calibrated inertial unit. It is used as the base for development custom inertial navigation applications.

OpenIMU300RI Evaluation Kit fixture and JTAG header board

The OpenIMU300RI unit with JTAG header board are mounted on the text fixture. The JTAG header provides means to debug/upload applications on evaluation unit.

ST-Link debugger

The ST-Link debugger is a standard JTAG SWD debugger provided by STMicroelectronics company. It is used for in-system debugging/uploading of applications via SWD interface.

OpenIMU300RI Breakout Cable

An included cable provides means of connecting unit to PC via RS232 interface, connecting unit to the CAN bus and powering up unit.

Next table provides connectors pin assignments in supplied cable
Signal Name
Unit
Connector
RS232
Connector
CAN
Connector
Power
Wires
GND 3 5   Black
VIN 6     Red
RS232 TX 5 2    
RS232 RX 4 3    
CAN H 1   7  
CAN L 2   2  

OpenIMU Evaluation Kit Important Notice

This evaluation kit is intended for use for FURTHER ENGINEERING, DEVELOPMENT,
DEMONSTRATION, OR EVALUATION PURPOSES ONLY. It is not a finished product and may not (yet)
comply with some or any technical or legal requirements that are applicable to finished products,
including, without limitation, directives regarding electromagnetic compatibility, recycling (WEEE),
FCC, CE or UL (except as may be otherwise noted on the board/kit). Aceinna supplied this board/kit
"AS IS," without any warranties, with all faults, at the buyer's and further users' sole risk. The
user assumes all responsibility and liability for proper and safe handling of the goods. Further,
the user indemnifies Aceinna from all claims arising from the handling or use of the goods. Due to
the open construction of the product, it is the user's responsibility to take any and all appropriate
precautions with regard to electrostatic discharge and any other technical or legal concerns.
EXCEPT TO THE EXTENT OF THE INDEMNITY SET FORTH ABOVE, NEITHER USER NOR ACEINNA
SHALL BE LIABLE TO EACH OTHER FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES.
No license is granted under any patent right or other intellectual property right of Aceinna covering
or relating to any machine, process, or combination in which such Aceinna products or services might
be or are used.